has anyone had issues with the fb3 dropping out randomly? I've noticed this more in show rider, but that is only because I've started to use it more and live quick less. At first I thought it was voltage related (The fb3 was only getting 4.6 volts because I had some huge-ass polarity protection diodes across the psu). but I took that out and have not seen an improvement.
also, sometimes it takes a minute or two to un-mount when I unplug the device, though it usually mounts up very quickly upon connection/power on.
I've also noticed (While running the fb3 as a dongle, ie: not connected to my scanner), that the red led that flashes to indicate laser emission stops after a couple minutes of run time in show rider. the software does not seem to notice this, but the frame rate does rise from around 50fps to 80 fps. I have not connected my scanner up to verify if this also correlates with a dropout in laser emission,but I feel that it most likely does.
I would also like to note that I am *so* not a senior member, I've barely scratched the surface of this hobby!
"TO DO IS TO BE" - Nietzsche
"TO BE IS TO DO" - Kant
"DO BE DO BE DO" - Sinatra