I'm always up to no good when I'm bored - but I was wondering what things you would change if you had to on this design.
It's basically an RGB setup with 7 laser heads. Total output would be 5 watts with the below configuration.
3) MBL-H-473 - 500mW 473nm
3) MLL-H-671 - 1,000mW 671nm
1) MLL-H-532 - 500mW 532nm (can be changed a higher power)
I choose these three models from CNI due to their size and weight - beam size is 3mm for each head. I'm waiting for Ava from CNI to get back to me on prices.
So - here is the drawing, done in MS Paint. The squares are PBS cubes, lower section are dichros - others are mirrors.
I'm open for suggestions.
Thanks guys!
Phil