Page 1 of 6 12345 ... LastLast
Results 1 to 10 of 57

Thread: Projector Enclosure Group Buy from Laser Visuals

  1. #1
    Join Date
    Jan 2008
    Posts
    49

    Default Projector Enclosure Group Buy from Laser Visuals

    Hi Guys,

    I'm trying a group buy on the Pre-Fabricated Laser Enclosures from Laser Visuals UK. We are after around 4, however, their minimum order now is 10, so i need 6 people up for buying these enclosures, as I can't justify spending a grand on cases!

    Julie from LV has quoted me 85 + VAT Per case, so thats what they cost.- and bearing in mind these are good cases, spec'd by the people who do the laser safety courses! They have holes punched on the back for 2 x 25 DSUB, Keyswitch, mains IEC etc and have loads of space inside

    Please visit: http://www.laservisuals.com/enclosure for dimensions and photos etc..

    Alex

  2. #2
    Join Date
    Jan 2008
    Location
    Napa, Ca
    Posts
    204

    Default

    Is that case big enough for an RGB with power supplies and all.

  3. #3
    Join Date
    Jan 2008
    Posts
    49

    Default

    I should think so- look at the dimensions of the case on the link. It's pretty big- half a meter wide!

    Depends on how big the PSU's etc are, but I reckon you'd easily fit it in there.

  4. #4
    Join Date
    Jan 2008
    Location
    Napa, Ca
    Posts
    204

    Default

    okay I am in for 1

  5. #5
    Join Date
    Jan 2007
    Location
    Cupertino, California
    Posts
    2,130

    Default

    I'm in for one, when can we get them?
    CLICKY!!!

    Admin: In the immortal words of Captain Planet: YOU HAVE THE POWER
    Admin: (To quit being a bitch)

  6. #6
    Join Date
    May 2007
    Location
    Milwaukee WI
    Posts
    1,355

    Default

    I'm in for at least one - maybe even two.

  7. #7
    Join Date
    Jan 2008
    Location
    Napa, Ca
    Posts
    204

    Default

    These are way too big for a single 1 watt green laser, power supply and scanner right?

  8. #8
    Join Date
    May 2007
    Location
    Milwaukee WI
    Posts
    1,355

    Default

    I dont know if I would say too big - but rather roomy - with space to stretch your legs

    Hmmm I just read that they're made out of steel - that disappoints me just a little bit. Any possibility they can make these out of aluminum?

  9. #9
    Join Date
    Jan 2008
    Posts
    49

    Default

    Yes they are quite roomy for just a single diode setup, however, it means there is plenty of room to add at a later date

    Plus there doesn't seem to be anything else on the market pre-fabricated that doesn't cost in excess of 300+ ($600+)

    I've decided we only need 3 now, so thats 7+ we have available. So just to confirm, how many people are in for sure and what qty do they want?

    Rgds

    Alex

  10. #10
    Join Date
    Jan 2008
    Location
    Napa, Ca
    Posts
    204

    Default

    I am in for 1 for sure.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •