Results 1 to 2 of 2

Thread: Beam polarisation

  1. #1
    Join Date
    Nov 2007
    Location
    Scottish Highlands
    Posts
    227

    Default Beam polarisation

    Newbie question here.
    I hope to combine two reds using a PBS cube.
    I understand that to do this the beams must be polarised at 90 deg to each other (I think!).
    If I were using two identical diodes (for example) then I can see this is simple enough. However, if the two soures are different, is there any simple way to determine polarisation? Or do you just rotate them to get brightest output?
    I have no power meter to check anything.
    Regards, David

  2. #2
    Join Date
    Jan 2007
    Location
    Sheepsville, Wales, UK
    Posts
    3,372

    Default

    David

    With 2 different diodes yes I would just rotate them and see what happens. When I do this I place a piece of white paper in the way of the unwanted portion of the beam after the cube. I then watch the spot on this as I adjust to see when it gets to the lowest point. You can also use a photodiode with an analogue meter (much easier to see than a digital for peaking something in) I bought a real cheap and nasty one for aboy 2.5 and have a PD with a large surface area on a bit of veroboard permantly attached. I call it 'peakymeter' works a treat
    hope this helps

    Rob
    If you need to ask the question 'whats so good about a laser' - you won't understand the answer.
    -----------------------------------------------------------------------------------------------
    Laserists do it by the nanometre.

    Stanwax Laser is a Corporate Member of Ilda

    Stanwax Laser main distributor of First Contact in UK - like us on Facebook http://www.facebook.com/FirstContactPolymerCleaner
    www.photoniccleaning.co.uk

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •