Does anyone know where I can pull a signal for feedback off one of these amps to connect into a scanfail board? The data I have shows everything but this signal.
Thanks
Rob
Does anyone know where I can pull a signal for feedback off one of these amps to connect into a scanfail board? The data I have shows everything but this signal.
Thanks
Rob
If you need to ask the question 'whats so good about a laser' - you won't understand the answer.
-----------------------------------------------------------------------------------------------
Laserists do it by the nanometre.
Stanwax Laser is a Corporate Member of Ilda
Stanwax Laser main distributor of First Contact in UK - like us on Facebook http://www.facebook.com/FirstContactPolymerCleaner
www.photoniccleaning.co.uk
For information the pin for feedback (position signal) is located on pin 2 of JP4 which is a line of pins that is located next to where the notch filter daughter board fits on - inboard of the daughter board.
Rob
If you need to ask the question 'whats so good about a laser' - you won't understand the answer.
-----------------------------------------------------------------------------------------------
Laserists do it by the nanometre.
Stanwax Laser is a Corporate Member of Ilda
Stanwax Laser main distributor of First Contact in UK - like us on Facebook http://www.facebook.com/FirstContactPolymerCleaner
www.photoniccleaning.co.uk