Very Small FB3 Enclosure

[dave]

Here are a couple of pix of the FB3 i just finished mounting today.

The first pic shows the extra boards - A very over kill power supply.. (I decided A linear supply has a lot less components than a switch mode, and is a lot simpler, so theory says it should be a lot more reliable) A front panel board, holding some LED's, and a last board with a few opamps to buffer the LED signals, and some other bits.

The bottom pic shows the completed unit. Polycarbonate front panel decal, key switch, and big red kill switch

[Lasernerd]

Here are a couple of pix of the FB3 i just finished mounting today.

The first pic shows the extra boards - A very over kill power supply.. (I decided A linear supply has a lot less components than a switch mode, and is a lot simpler, so theory says it should be a lot more reliable) A front panel board, holding some LED's, and a last board with a few opamps to buffer the LED signals, and some other bits.

The bottom pic shows the completed unit. Polycarbonate front panel decal, key switch, and big red kill switch

Now that is more like it!
very nice work!

[buffo]

Damn! You do nice work, Dave!

That's very cool. And all in a 19 inch rack mountable package. Awesome!

Adam

[Angelillolaser]

HI Guys good Job!
Hardware and software are the best
I made this small box with switching power supply inside
I need change the logo for pangolin inside, but I made only the box
cheers!

[thesk8nmidget]

very nice!!

lots of fantastic engineering skills!