hi, i recently got a showlaser without any manual. i am very new to this. the name is: lyt-or, athena 4, cartoon laser.
there is a usb graphic interface card. i plugged it to the pc with a usb-wire. i plugged the graphics signal out (from the interface) to the lasser (pc in, d-sub 9pin).
on the interface there is another port: motorhead signal out (XLR). on the laser there are XLR ports as well: in - DMX - out. and a 25 pin ILDA DB 25F connector.
the software that comes with the laser is called i.top (iTopMovingEn and iTopEn).
so my problem is, as i'm absolutely new to showlaser-performance: how can bring the graphics/frames from the software to the laser? as i told above i plugged the wires. but i think something is missing as no wire goes to the ilda connector.
maybe i should go from the "motorhead signal out" (from interface) to the 25pin ilda connector (at laser-box)? but is there a wire from XLR to 25pin??
hope i could write it down quite understandable. if anybody has some hints i am thankful.