Hi,
I have for sale, 1 large enclosure suitable for a good sized RGB laser projector.
If you have been to UKLEM 1 or 2 you will have see this case. If not, there are a couple of pics attached. My RGB Lived happily in it for some time.
Included in the sale:
1) Inner frame - Aluminium in black EPC, NO Breadboard, lasers, scanners etc, just the frame.
2) Outer Skin 16swg mild steel, epoxy powder coated in a stunning shade of black. A couple of small knocks and scratches as expected, 3 parts - Front/Top, Bottom/Sides and Rear Panel. Hanging bracket and truss clamps NOT included.
3) 8 x 50mm fans and grills, fully wired four front and four back blowing in and 2 60mm fans on the side blowing out.
4) DB25 In and DB25 Out (to second projector) fully wired with ribbon cable. Apertures cut for DMX in and Out should you need them.
5) 2 toggle switches for Invert X and Y, just need soldering to the ribbon cable.
6) All Power connected, IEC in with illuminated Power switch and safety keylock.
7) Two front apertures with Antireflective glass.
8) All screws to hold it together.
So, all you need are the innards, baseplate/breadboard, lasers, scanners etc.
Looking for £100 plus delivery, cost me a lot more to build it. Please bear in mind this is a large heavy item, so delivery costs are expected to be quite high... Local pickup is always available of course.
Dimensions are approximately 820 x 290 x 155mm.. If anything a couple of mil bigger...
Cheers
Mark