PureMicro lasershow :-)

[RGB LASER VERKOOP]

Attachment 30327
http://youtu.be/UK64Z_ySH5k

Enjoy

laser greets joost

[FourDee]

Did you use a BAM?
If the video was shot at only 35m from stage it looks like the beams are entering the crowd at about 10m or so ....

[RGB LASER VERKOOP]

The beams go to public after about 10m yes, and i use safty zone.
What is BAM ? (lenz for output window ?)

laser greets joost

[FourDee]

Beam Attenuation Map

[RGB LASER VERKOOP]

in phoenix they call it safty zone ;-)

[sbk]

Very nice show. I like when it stays simple without a lot of simultaneous different colors.

I can't tell where was the pure micro though... Maybe just the RGBLaserSystem are the two at the most upper?

[RGB LASER VERKOOP]

2 on top = 3W rgb lasersystem (2,8 - 3,2W)
2 outside = 1,8W Pure micro
2 inside = 2x kvant spectrum 1,6 - 1,8W

greets joost

[sbk]

I was right so Difficult to tell, only the green of the RGBLS was sometimes more powerful...
They all do a great job for such low power (I mean, 300-400mW green). The dark environnement helped a bit I think.

[RGB LASER VERKOOP]

yes, but when you standing in FOH on 35meter it was so bright.
i look to the lasers from 2300 till 0700hour, pain my eyes ;-)

the video and pictures are not so good as in reel!
i try many different camera's but no cheap camera's work good.
and i scary to put a expensive camera in the bright beams
i had one time killed a camera in the first day with my lasershow (demo is studio at 10 meters)

laser greets joost

[sbk]

Of course it was bright, you had 13-14 watts of laser

Yes it's impossible to make a video looking as good as in real, even with most expensive ones.

You could still try to add a blackout mask where you place the camera, if you don't move it it will be ok... Or calculate the MPE and if it's not too high it will not damage the camera.