Scanpro20's program board dipswitch help!

[z-tek]

with me i soldered the DB25 connector using the information from
http://www.photonlexicon.com/forums/...6&postcount=18


as soon as i plugged in the laserboy device it switched to ILDA mode!

the only this is that i cant get my system to blank at all! and my laser is DEFINTLY NOT full power!
its really anoying me!:@

[skipper]

Z-tek, I also bypassed the controll board and it works great. I am going to work on the blanking right now. I am still a bit unhappy about waiting for an answer on the problem with my board and all the extra work for the go around.
If you need help with the blanking let me know.

Dave, if your reading this please can you give me an update on what to do with my controller/DMX board?
With the lack of pin-out info it seems there may be a problem with my board.
With signals bypassed the board is taking up real estate in my setup.
Bob

[dave]

Hi Bob,

Maybe you would find faster service if you actually sent me a private message?

Please check your messages

Thanks

[dave]

These boards are designed to operate with TTL lasers.. Hence you are having trouble with (im putting a stab in the dark here) a analogue laser.. You will need to buffer the output

the only this is that i cant get my system to blank at all! and my laser is DEFINTLY NOT full power!
its really anoying me!:@