Additionally, his name on pl is pishtak. I emailed him not too long ago and he was super nice, sent me the complete schematics, complete board layout in .pdf format as well as .brd and .sch.
I remember him saying the parts were only about $50. As far as the boards go, that would be a different story. Small quantities from a manufacturer would be spendy and every time I have tried a double sided board, I have jacked it up (not to mention all the through board jumpers). I am ready to give this a try though. Anyone have any tips on double sided boards or moreover, a cheap manufacturer that would not charge an arm and a leg and first born for 10 pieces?
Last edited by absolom7691; 11-01-2008 at 10:19.
If you're the smartest person in the room, then you're in the wrong room.