George at Cham Tech has asked me to sell off his remaining inventory of laser enclosures. Currently I have 4 enclosures here, but there are another 10 available.
These are made of steel and powder coated black. Rear panels have cut out for IEC, XLR, D conn, switch etc. They also have ventilation slots and a hanging bracket is included.
There is an internal horizontal shelf neatly dividing the projector into 2 separate sections. Dimensions are as follows-
Depth: 310mm
Width: 245mm
Height: 155mm
Internal Height Upper section: 90mm
Internal Height Lower Sectiom: 60mm
Although an RGB system would be a squeeze, and RGY system shouldnt be a problem. I also guess you can get a 1+ watt DPSS in there without any difficulties. George will not be making any more of these cases, so once they have gone, that will be it.
I apologise for the poor pictures, these were taken tonight using flash, the marks are merely dust. I will clean these up and take better pictures over the weekend in daylight.
Cost of these enclosures is £75 each. Postage (DHL) is an additional £10
If you buy 2, postage is still only a tenner.
ONLY 1 LEFT
EDIT: NEW PICTURES BELOW