New DMX RC-Servo and DMX TTL convertor boards from LSP

[dave]

Single channel DMX RC-Servo Driver



Pretty straight forward board. will drive your typical RC-Servo from DMX. There are jumpers to invert the servos position, and decrease the travel of the servo to 1/5th of its travel, making it useful as a poor mans GM20 **servo NOT included**

A couple of uses that come to mind are using the servo to drop a grating down in front of a set of scanners, or as a cheap beam switch..

Manual here: http://lasershowparts.com/files/Manuals/DMX/DMX01S.pdf

$60AUD, with free shipping via airmail to PL members



Single channel DMX TTL decoder



Even simpler than the servo board. Single channel DMX-TTL decoding, with a jumper to invert the output

Manual here: http://lasershowparts.com/files/Manuals/DMX/DMX01T.pdf

$50AUD, with free shipping via airmail to PL members


These ad to our existing boards, being a single channel, and 8 channel relay card, and a 16 channel TTL card.

[Stuka]

Nice!

After a little testing today, I plan on posting some info for a "special" servo I found that would be perfect to use with these!!

How soon will the new offerings be available on the web site?

[dave]

Hey Randy,

Don't think Ill get a chance to get them up until next week,once I come back from a well earned holiday

I forgot to mention, I have sent one of each of DMX01S, DMX01T and DMX08R to both the UK and USA meets as door prizes Pitbull and Buffo know all about it

[DjDevNull]

I like the TTL board. But here is the servo board I have.

http://home.att.net/~northlightsyste...2toRCservo.htm

It can control 8 servos plus it works via serial too.

[dave]

8 channel board coming soon.. The firmware I actually wrote as 8channel firmware, then stripped it down to single channel..

I could quite easily add rs232 functionality for not much effort, but for laser use, I didn't see the point!

[Stuka]

Hey Randy,

Don't think Ill get a chance to get them up until next week,once I come back from a well earned holiday

I forgot to mention, I have sent one of each of DMX01S, DMX01T and DMX08R to both the UK and USA meets as door prizes Pitbull and Buffo know all about it

No problem - enjoy your holiday!
And thanks in advance for the donation to FLEM!!

I like the TTL board. But here is the servo board I have.

http://home.att.net/~northlightsyste...2toRCservo.htm

It can control 8 servos plus it works via serial too.

Same source I've been using, discovered "pre-Dave".
It's good to have options, expecially when Northlight Systems and LaserShow Parts are both such great companies to deal with!

[Banthai]

nice one dave

where you going then ? i can reccomend St Kilda or a couple of sleezy lap dancing bars in paramatta

have a good time buddy and enjoy

[p1t8ull]

I forgot to mention, I have sent one of each of DMX01S, DMX01T and DMX08R to both the UK and USA meets as door prizes Pitbull and Buffo know all about it

Boards are already here and ready to d'sh out on the door, thanks again Dave and Aijii

a well earned holiday

Earned indeed. Have a good 'un!

[dave]

Just a quick note -

I have a few of each built up and up on the store