small beam and divergence red lasers from Laser-wave

[bridge]

Hi guys,
I 'd like introduce our new type red lasers to all of you, it is very small beam and divergence.wish all of you like it.
beam is about 2mm at the aperture, divergence is <1 mrad
laserhead sizes is 102*50*48.8mm
Analogue, up to 30KHZ
the control board is inside the laserhead, you only need any 5V DC power supply and Analogue signal can power on it, so connect to your green or blue 5V DC power supply in your projector, that is very simple, .
640nm, power is up to 300mW, 658nm, power is up to 200mW, the bigger power one will soon published, thanks!
pictrues is as below shows.
any interesting, please contact our distributor here:
Rob(stanwax, www.laser-wave.co.uk)
Marc(gottauvlasers, www.ctlasers.com)
David(Dave, www.lasershowparts.com)
any more information or questions, please email us, info@laser-wave.com or bridge@laser-wave.com.
thanks for all of your support, your reply, interesting, encourage is the most driver for us to make better and better products, all laser-wave men would like do their best to supply you quality products and best service.
Best regards!
Bridge

[tocket]

Finally an affordable (right?) 640 nm with good beam specs! What's the polarization of these lasers?

[lamborgini8]

Looks nice, estimated price?

[allthatwhichis]

And I get to test one right? I got an open spot in the projector...

[mophead]

I got an open spot in the projector...

Yeah. Me too. It would save me lots of work.

/me begs......

[FourDee]

Figures ... just when i got my dual red setup ready ...

[dave]

We should have one of them in stock, ready to ship in the next couple of days

[LaserWizard]

Wow, just what the doctor ordered! This is going to help out the whole laser show scene!

How much approximately?

[dave]

Well under the 1k USD mark

[ledfreak3d]

Nice yet again a great laser wave product.
if i can ever afford one im getting it