Hi
i have one question.
I have two green 532nm 100mw eco (from laserworld).
For you are possible change driver example whit Sam driver?I need little eco analog green,and if are possible i use this modul.
thanks
Blu
Hi
i have one question.
I have two green 532nm 100mw eco (from laserworld).
For you are possible change driver example whit Sam driver?I need little eco analog green,and if are possible i use this modul.
thanks
Blu
Depends; does it have a TEC in it? I have ran a big dipper green off a die4drive. It only had the positive and negative power leads going to the head. If your greens have more than two wires; they might be for the TEC and then you might not be able to drive them from a DIY driver. I could be wrong, but if you are like me, and since you asked this questions I will assume you are, swapping a driver out for a laser that is TEC cooled might be a bit much for you as it would be for me.
Love, peace, and grease,
allthat... aka: aaron@pangolin