I just realised that I have not yet shown you guys my projector.
It's been ready for 6 months now.
I did the best I could with the housing (and to be honest I hate the shiny finish, I'll probably change that to matte sometime soon)
Specs :
- CNI Green 200mW measured at 300mW
- CNI Blue 100mW measured at 120mW
- Homemade dual red estimated to have approx 400mW
- DT40pro's
- FB3 for control
So here it is (be gentle on me) :
Front : Hoya filter on the output and grille for the electronics compartiment
Back : Powercon for power (duh!), ethercon for signal and a jack for shutter
Bottom : An alu heatsink is incorporated for the galvo drivers
Inside : coulour mixing
And some beam shots :
![]()