Results 1 to 3 of 3

Thread: not staying in projection zone

  1. #1
    Join Date
    Jan 2009
    Posts
    151

    Default not staying in projection zone

    Last night i was having issues with the overhead sweeps that had zones 8 (scanner1) and 9 (scanner2) setup to sweep over the crowds heads becoming part of other zones i had programmed in. I tried stopping and checking the settings but it was all correct. I have a feeling it might be a key effect or effect making it project to a different zone.
    does anyone have any other ideas?
    1.5W RGB internal FB3 scanpro 30's
    500mW RGB scanpro 20's
    300mW 532nM scanpro 20's
    600mW RG 4 head

    Livepro + FB3XE

  2. #2
    Join Date
    Apr 2008
    Location
    Amsterdam, NL
    Posts
    2,098

    Default

    Each cue can be assigned to a projection zone, please check cue tab

  3. #3
    Join Date
    Jan 2009
    Posts
    151

    Default

    i worked out it was because i had 2 lasers running, one running off track 1 and the other off track 2. i had to set tracks 1 to project to a zone using scanner 1 and track 2 to project to zone using scanner 2. this made the cue loose its projection zone and project to the tracks zone.

    I want to run 2 lasers and have each laser on a different track but then i loose all my targeted beam and overhead sweep zones. otherwise its just setting the zones for the cue and running the 2 lasers of the same track.
    1.5W RGB internal FB3 scanpro 30's
    500mW RGB scanpro 20's
    300mW 532nM scanpro 20's
    600mW RG 4 head

    Livepro + FB3XE

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •