Hello,
Several years ago, before I got bit hard with The Addiction (and started buying up Lexel's like they were going out of style... Two Lexel 75's, a Lexel 90, and an ALC909, along with the toys that go with them), I bought an ALC60X head from MWK. The head is just the stock Xerox type head, no multiline optics or anything. In any case, I didn't buy a power supply with it. Instead I planned on building my own. Which, I did, to some extent.
I've never seen the tube lase, although testing with my oudin coil shows that the seals must be intact -- there's still argon in it. I got impatient one day and, figuring my power supply was at fault, I tried to jump start the tube with my oudin while under power from my PSU. My ignitor circuitry (the voltage doubler +450V supply) seemed to be at fault so I figured a zap with the oudin might get enough plasma going that the main supply could kick in...
Well, of course, I ended up frying the ignitor board built into the head. I think I blew up the transistor or SCR. Saw a flash out of the corner of my eye, and no more tick-tick-tick after that.
Anyone have any advice on repairing these boards? I'm worried that there might be more fried than just the SCR/transistor...
Thanks,
Brad


bradstockdale
Reply With Quote
