Member
Uniphase 2201-40MLA Control Help
Hey my gaseous brethren. I need some help. I have acquired a Uniphase 2201-40MLA argon system. The beast runs great. I need, however, pinout information for the power supply. It's currently jumpered to operate but input current was controlled by a computer system. I need to know what all those pins do so I can increase the current. Thanks guys.
Last edited by frothychimp; 06-20-2009 at 16:58.
The Frothy Chimp
Cynic Extraordinaire
Back off man, I'm a scientist
Good whiskey, fine cigars, long legged women and blues guitar.
That's what I like.
The strong shall stand, the weak shall fall by the wayside.
This brings back memories. I built one of these things a few million internet-years ago. I omitted the LED indicator; figured the laser and fan noise was adequate.
http://www.repairfaq.org/sam/laserasc.htm#asccu1r
Senior Member
I hope the attached help...
Dan
Member
Thanks guys. I guess I am argon myopic for not thinking about Sam's for the information. I'm there all the time for solid state information. Change the lasing medium and all of a sudden I'm lost, lol.
The Frothy Chimp
Cynic Extraordinaire
Back off man, I'm a scientist
Good whiskey, fine cigars, long legged women and blues guitar.
That's what I like.
The strong shall stand, the weak shall fall by the wayside.
Posting Permissions
Reply With Quote
Admin