-
1998 general scanning hm1400 laser problem
Hello everyone
i am very new to this site. I have a general scanning yag that won't load the start up codes on boot up. which gives a pass 2 time out error. Can any one tell me what is wrong. It has the H/C helper card. I'm not sure if that is bad. this happens during the MCL_init file.
thanks for your help
Damien
-
i fixed it.
Yes I fixed. It turned out to be a bad Mother Board. I dropped the card and the hard drive in and old computer waiting to be scrapped and the darn thing is working fine.
Thanks
Damien
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules