-
Not software this time again,this will be difficult !
I am a little new. The KNbO3, spoken shrad. It's me who find it in supertechshop,the same company that SVCompucycle !
On the 3 crystals, there are 2 different types. The pictures of the inside of the Protera,should help us, is sure ! 
Good luck,for you !
Last edited by james531; 07-27-2009 at 09:37.
-
The main problem is that the KNbO3 doubler crystal is extremely temperature sensitive, at 25 deg C it's center wavelength is 980nm, at 28 deg c it's center wavelength for shg all the way to 986nm.
In short, you need to hold it within a fraction of a degree c or the efficiency drops like a rock.
If one is brave you can do away with the controller module completely and run the head with a wavelength electronics TEC LD driver and another bigger TEC driver and mount the head assembly on that to give you better stability ranges. Good luck finding the correct parameters for operation though!
-
we have a 0.005°C precision low power TEC regulation evaluation kit, which, under "not ideal" conditions (unoptimized thermal feedback), should do 0.01°C to 0.05°C of precision easily, so tempreature control is not a problem
anyway, the KNBO3 we are using are not those you sell but are from another seller, don't know if they are the same (I think those we are using are castech 2*1.8*5mm, S1 AR@976nm,HR@488nm and S2 AR@488nm and AR@976nm
the OC we are using, though, is from your stock
could you send me any information about them in PM please? ray of curvature and coating details would be welcome if you have
-
my replacement head will be here tomorrow... I'll let you know how it goes.
-
I actually got my head today. Curiously, the part where the power rating was stated was torn off... and it's definitely not 15mW like the auction said, but it works!!
It appears to be maybe 5mW or so, but for what I paid, I'm not going to complain anymore. I'm just glad it works at all. It appears about as bright as my single line 488nm argon did at idle, which was "6mW" according to the power supply.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules