Pat B
laserman532 on ebay
Been there, done that, got the t-shirt & selling it in a garage sale.
forgot one other question...are the lamp electrodes in the water or not?
Pat B
laserman532 on ebay
Been there, done that, got the t-shirt & selling it in a garage sale.
Hi,
Continuum recommends a couple grams of Cloramine be added to the cooling water to remove biological crud; then drain, flush and refill. Dick Anderson at Anderson lasers also told me about this stuff that you can get at Fisher Scientific. Good luck. Phil, 142laser
Phil Bergeron( AKA 142laser)
Hi all...
Many thanks for your help and pointers. Finally had a chance to play today.
Gogu - cheers for the link to directedlight. Unfortunately they don't do the Alcon 532.
Pat - I don't know what "cavity snot" looks like. The residue I had was almost black. When the reservoir was cleaned out it came off almost in a sheet as a stream of water was played on it. When scraped together it was gelatinous. I tested a sample of the gelatinous black gloop with some conc H2SO4. It did not dissolve. (Wish I had some HCl here as well) If it was a metal oxide (or hydroxide) from corroded cavity bits I would have expected it to dissolve. I'm guessing it is organic. And yes - the lamp terminals are in the coolant water.
Phil - thanks for the info on Cholramine. I'm afraid I got a little impatient this afternoon and after testing compatibility with stainless steel and aluminium I ended up flushing the head with Sodium Hypochlorite solution. This loosened the black residue and caused it to be washed out into the reservoir tank - looking like lots of little sooty flakes.
I left it running warm hypochlorite for 20 minutes then flushed with tap water for 20 mins, followed by a flush through with DI a couple of times followed by a refill, DI bag back in. Flow for 30 minutes then re-enabled the lamp.
Power was only up 5%. I followed the head alignment tweaking procedure and gained another 5%. I'm coming to the conclusion it is most probably the lamp.
The spec is 99 to 109V, 2" arc, 20A, 2kW, 4mm bore.
I keep looking on ebay but only the 3" arc QCW12A keeps turning up. (3 for $90) Any idea where I might find a reasonably priced 2" lamp?
Attached - a pic of the residue and a pic of the laser running just shy of 3W into a fiber endoprobe placed on the optical plate.
Cheers,
Robin
Lasers and beer don't mix. After 2 beers I lose coherence.
What you're describing sounds like the gunk we got in our cooling troughs when I worked for a wire factory. I'm not sure what it was, but it smelled like sewage. Bleach usually prevented it.
I wasn't willing to get my nose close enough to smell it but it didn't look pleasant.
I have spent the morning stripping down the head.
Looks like I wil be needing a new lamp after all
I have measured the lamp. 191mm overall, 4mm bore, 51mm arc, ball ended.
Looks like the smallest of the Perkin Elmer ball ended QCW Krypton lamps.
Anyone know of a low cost source ??
Lasers and beer don't mix. After 2 beers I lose coherence.