Unmounting laser diodes... how?

**djlorenz** · 07-14-2009, 05:48

i guys!
i have 2 broked red diodes taken from a laserworld rs400rgy projector,
i wanna use the housings and the optics for a dvd-burner diode... how can i unmount this housings? there are no screws!

thank you very much

Lorenzo

**ledfreak3d** · 07-14-2009, 05:58

hi Lorenzo

there schould be a screw somewhere under the stickers.
just remove that and u should be able to screw off the back part

the diode is just hold in place by the back part thats screwed in

**djlorenz** · 07-14-2009, 06:09

unfortunatly there are no screws under the stikers

has anyone some ideas?

**ledfreak3d** · 07-14-2009, 06:10

then just screw out the lens assy and u should be able to do it that way
u need to realligne everything anyway with the new diode in there

**Laserman532** · 07-14-2009, 06:29

throw it in the trash and use an aixiz moduel

**ledfreak3d** · 07-14-2009, 06:31

i would think twice about that these have mutch beter heatsinking.

where does the aixiz has none realy

**djlorenz** · 07-14-2009, 06:31

the only thing to do was... cutting!!!

now i will try to change the laser diode

i dont wanna spend money for this laser... is only 40mw i think... i wanna build it up only for pleasure

**Laserman532** · 07-14-2009, 07:17

I challenge you to melt this

http://www.microlaserlabs.com/produc...g4iqbiscaa6gp5

**JimBo** · 07-17-2009, 02:05

Why cut the housing?
They will either be loaded via the front, unscrew the lens, then a retaining ring then pull out forwards. Or from the back with a similar type of fitting to the lens.

Jim

**djlorenz** · 07-17-2009, 02:06

unfortunatly not...
is a unique fusion...

the only thing to do is cutting the back

Thread: Unmounting laser diodes... how?

Thread Tools

Unmounting laser diodes... how?

Posting Permissions