setting up scanlsp 20k kit

[ledfreak3d]

the beam should come out of the scanners the same way it comes into the scanners
100 % horizontal.

thats sucks that the mirrors got broken
there very fragile and break easyly
but u already found that out the hard way

[dave]

yep, at right angles both vertically and horizontally with no signal input..

Glad I could talk you thru it over the phone! I forgot to ask, what time was it there when I was speaking to you? It must have been late..

[ndrew2505]

yep, at right angles both vertically and horizontally with no signal input..

Glad I could talk you thru it over the phone! I forgot to ask, what time was it there when I was speaking to you? It must have been late..

it was only 11pm here. its not late to me considering i dont go to sleep til about 5 am on most nights. night job and all ya know..?

hey dave do you know the mounting screw size for the scanlsp mounting holes? i got a tap and die set but the m4 tap barely fit and it seemed kind of tight..

[dave]

I would guess m4, but Im not too sure.

Dave

[ElektroFreak]

Mine is m-4. I'm pretty sure they're all tapped for the same size screw. I can't vouch for the consistency of the Chinese machining equipment that they used to construct those blocks..

[ndrew2505]

im waiting on an order from mcmaster now. they were m4 and the screws on the bottom of the 50mw adjustable 532 from aixiz is m3. had to order more stuff for 360 RROD kits anyway.

any machinists here?

[MisterWilling]

I'm here, but I guess you all ready knew that :-)

[ndrew2505]

I'm here, but I guess you all ready knew that :-)

lol your already hired.

can anyone help explain how to setup the flexmod drivers? i can set the bias current but for some reason i dont get any current at all when i put the 5v to the gain..?