Looks like I will be replacing the red and green lasers in this projector. They just aren't strong enough. I don't know why or how but they are not the 300mW that they are supposed to be....not even close. Plus I lose 50% of the green after it gets through the optics.
Did you get 5 volts to the blanking leads?I remember that thing at FLEM and it was giving the Kvant a run for its money.
Yeah I gave it 3 volts, then 4 volts then 5 volts and even 6 volts.
Something's definitely not right... and I can't get a hold of Yobresal today...
--DDL
I suffer from the Dunning–Kruger effect... daily.
Yeah it looks really good. The red and green lasers though are only putting out 100mW each before optics. I wish I could figure that one out.
I'm curious about something, Yobresal.. You recently sold be a ~500mW RGB. At the time you mentioned how the red and green modules weren't up to spec on that system either. I have since metered them each before optics and they are all over spec.. Do you think it's possible there is a problem with your meter or methods? I'm sure that has already occurred to you, but I find it weird that the red and green modules are the problem here just like they were the problem in the system you sold me.
Well that's a usefully information I could have used a while ago. If this is the case then my problem is external from the projector. It must be my fb3 or laptop bus port. My laser meter is perfect. The flaw in my testing the voltages are probably due to the multimeter instead of an osciliscope. Maybe I need to send my FB3 out to someone for testing. Thanks for letting me know electro, looks like you got a Heck of a deal then eh? : )
Any volunteers?
Do you need to send the FB3 or power meter? Assuming you have an external 5V supply and are using that on your laser blanking leads, the only suspects are the lasers or the meter. If you are using the FB3 to try and get a full power beam to measure then try moving the red or green to the blue ILDA pins and measure from there. Assuming your blue is producing what it should.