Anywhere know where I can get a cheap breadboard in the UK, can get a slab of Alu for £40 but as soon as its got holes all over it they want £150!!
Anywhere know where I can get a cheap breadboard in the UK, can get a slab of Alu for £40 but as soon as its got holes all over it they want £150!!
optical breadbord and cheap do not excist in the same sentence![]()
Do not look into laser with remaining eye
Need laser repair contact me !!!!!!
I made my own from 1/4" aluminum plate and drilled and tapped 594 holes by hand. It is time consuming, but much cheeper that buying one prefab'ed.
Lazerjock
PM sent.....![]()
Quote: "There is a theory which states that if ever, for any reason, anyone discovers what exactly the Universe is for and why it is here it will instantly disappear and be replaced by something even more bizarre and inexplicable. There is another that states that this has already happened.”... Douglas Adams 1952 - 2001
Thanks guys, think am gonna go down the Aluminium sheet route and drill my own holes!
The tapping head will cost more than having a machine shop do it.
If you are going to do it your self here are some tips.
I am assuming that you are going to be using a hand drill.
Things you will need:
Drill
Drill bit : 5mm ( get a good one )
Tap: m6 (spiral point, works WAY better than a standard gun tap.) get a couple you will probably break one.
Taping fluid. ( really important!!! not optional) rapid-tap , cool-tool , tap magic. something similar. motor oil is not a substitute. Last resort WD-40.
Punch (spring loaded)
Drilling:
Use spring loaded punch, layout your grid 24.5mm? and punch every hole location first.
Drill holes. Use cutting oil on every hole. Drill, Deburr.
Put the tap in your drill. Get real familiar with the forward and reverse buttons.
Clamp the part down to something so it won't spin around.
Dip or spray your oil on the tap:
Start at a medium speed and and push the tap into the hole . Stop when you get through, reverse and back out of the hole. The tap will dictate how fast it feeds, just let it.
After a couple of holes clean the tap if it is building up chips. compressed air works great for this or else a tooth brush. sometimes you can just blow on it.
Make sure that you are perpendicular to the hole when tapping if you change your angle at all while in the hole you will snap the tap. They don't have much tolerance for off axis movement.
I can not stress enough how important a tapping fluid is. Motor oil is designed to keep parts from making friction. Cutting oil is designed to allow friction but keep the cutting edge lubricated. Aluminum is also soft it will gall or build up on tools if you don't use some lube.
good luck.
Chad
When the going gets weird, the weird turn pro.