Scanner/Color/ Test board

[mixedgas]

What would you be willing to pay for a board that:

A. Lets you verify the average and peak voltage of your color signals.
B. scans a ramp from left to right allowing you to watch a signal in laser.
C. Lets you verify the level of a ILDA differential signal.
D. Provides a reference scanner level and a reference color level.
E. Outputs a pulse in the middle of the ramp to look for jellybeaning or to tune damping.
F. Outputs a 30 hz Quad Sqare.
G. Outputs Static levels of RGB for test.

30$ ? 45$ ?

Steve



Steve

[Laser Ben]

What do you mean by "Lets you verify the average and peak voltage of your color signals."? The rest sounds very good, would pay for that!

How about a projector tester which plugs into the ILDA port and can so most of that? That way you can diagnose what is going on with a simple box and not having to open the projector.

[daedal]

You would have me as a customer as well.

--DDL

[mixedgas]

What do you mean by "Lets you verify the average and peak voltage of your color signals."? The rest sounds very good, would pay for that!

How about a projector tester which plugs into the ILDA port and can so most of that? That way you can diagnose what is going on with a simple box and not having to open the projector.

4 things,
Absolute rectifier, 2 peak detectors, scope mode, and integrator.

If misadjusted, Can be Calibrated with on board accurate reference, a voltmeter, and sound card scope software if needed.

Signals will be both ILDA and on a breakout strip/phoenix connector.

Steve

[Laser Ben]

Perfect, that is a great idea!

[Mr.Coffee]

sounds good to me

[sugeek]

I think this would be a wonderful addition to my tool box, of course dependent on price (Probably around $50, so no fancy case).

-Adam

[Doc]

You'd have to be a fool to turn it down at $80, no question

Ian

[ImageLight]

I'm in at the $50.00 level

Mark

[allthatwhichis]

Can we get an ILDA and LM test pattern also?