Results 1 to 5 of 5

Thread: Need Help Jumping a Switch on a Laser

  1. #1
    Join Date
    Sep 2009
    Location
    Charlotte, NC
    Posts
    38

    Lightbulb Need Help Jumping a Switch on a Laser

    This forum rocks

    I'm doing a project with these little laser diodes where I need to jump/skip a little momentary push button on the driver. Jump, as in I'm going to use my own push button on a controller some distance away instead of the push button on the driver.

    I tested with my multimeter and found where conductivity is before and after the button is pushed...but there's 2 connections on each side. (not just one) Which side do I use?

    Thanks for anyone's help. I like to be very sure of something before I go hooking stuff up

    I've attached some close ups of the diode+driver below.
    Attached Images Attached Images

  2. #2
    Join Date
    Jun 2007
    Posts
    101

    Default

    They're just extra terminals, the switch only has 1 pair of contacts (2 connections)

    You can check this with your meter, in your last pic the 2 left contacts should have continuity between each
    other no mater what state the switch is in and the same with the two right ones

    ie, The top right contact will be shorted to the bottom right contact inside the switch plastic.
    Similarly the top left will be shorted to the bottom left inside the switch .

    If that is correct (which im 99% sure it will be) then you can wire up your 2nd switch between any left and any right contact.
    Last edited by Psi; 09-30-2009 at 05:15.

  3. #3
    Join Date
    Nov 2007
    Location
    Cairns, Australia
    Posts
    1,896

    Default



    Thats how the switch is connected internally. When pressed, it bridges the gap between those 2 red boxes I put in. Just put your switch there.

  4. #4
    Join Date
    Sep 2009
    Location
    Charlotte, NC
    Posts
    38

    Thumbs up

    AWESOME

    Thanks everybody. I just wanted to check on that. Very appreciated.

  5. #5
    Join Date
    Jun 2007
    Posts
    101

    Default

    If you plan to unsolder and remove the switch you may need to bridge the pins in the same way the button does now. (Since removing the switch would remove the internal connections between the pcb pads). It would depend if the PCB layout relies on these internal connections or not.

    If you leave the existing switch there and just solder wires to the two connections then you don't need to worry about it.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •