Front surface mirrors for sale!

[Laserman532]

www.MicroLaserLabs.com has stocked Enhanced Aluminum Front Surface Mirrors. Our standard sizes are (approximate Dimensions) .25" x .25" x.060, .375" x .5" x .060, .5" x .5" x .060, .5" x .75" x .060. Other sizes are available upon request. These mirrors are NEW and come with the blue plastic protective coating installed. These mirrors are great for routing beams from diode lasers and can be used as scraper mirrors for beam combining and beam mixing. Features of Enhanced Aluminum coatings offer excellent performance of >94% reflectivity at 45 degrees. Used where high reflectivity across the entire visible spectrum and very small physical size are required.

http://www.microlaserlabs.com/index....9vftf3eg4llqq0

[allthatwhichis]

Hey... Can I make a request? How bout some "beam" bounce mirrors on mounts? The big ones for audience beam bounces. 2 or 3 inch.

[Laserman532]

i'm on it how many do you want? can you hit 2 to 3 inch mirrors with scanners?

[swisseuro]

i think 4" x 4" would be better... that's about 10 x 10 cm, you can hit that mirror ok

[Doc]

My DTs reliably hit 4 x 4s from 60' but I wouldn't want to go smaller (mainly because of my weary eyes struggling to find the b*stards on a congested truss).

I will be looking for some more soon as they where a PITA to make and I want to add some difraction bounce back fx (so I'll need two with mirrors and two blank.

Please include a loop for a safety lanyard.

[mccarrot]

Features of Enhanced Aluminum coatings offer excellent performance of >94% reflectivity at 45 degrees. Used where high reflectivity across the entire visible spectrum and very small physical size are required.

Have you measured them with these result? and are the results the same for all colors?

Or are these "Chinese" specifications given by the manufacturer??

[Laserman532]

Have you measured them with these result? and are the results the same for all colors?

Or are these "Chinese" specifications given by the manufacturer??

I have not measured them, data is probably chinese specifications given by the manufacturer. Generic chart attached.

[Laserman532]

I just added a few more sizes that may be more applicable to different types of applications. I know the prices seem a bit higher on the larger mirrors but you are paying for my labor to cut these PITA's and the scrap that occurs. Any way check it out if you would. Sold quite a few over at LPF..GOD love em'.

direct link to Front Surface Mirror Page - http://www.microlaserlabs.com/index....l1uoa16mpk1ul4

[ElektroFreak]

You knew just what to say to 'em over there.. I've got no issue with TJ myself (he's quality entertainment..), but he sure has pissed quite a few people off. There's plenty of folks over there that would have called him out without anyone sweetening the deal, but then you offered an incentive..

[Laserman532]

You knew just what to say to 'em over there.. I've got no issue with TJ myself (he's quality entertainment..), but he sure has pissed quite a few people off. There's plenty of folks over there that would have called him out without anyone sweetening the deal, but then you offered an incentive..

im only here to please. I enjoy rubbing dog doo in someone's face who deserves it, even it if cost me. Rubbing Dog Doo in a trolls face...PRICELESS.