Results 1 to 5 of 5

Thread: CNI Laser PS Adjustment

  1. #1
    Join Date
    Jul 2009
    Posts
    22

    Default CNI Laser PS Adjustment

    I have a 1.5W green laser (analog modulation) from CNI.

    It leaks a bit of green with no input signal. Does anyone have information on adjusting the power supply? I found a thread showing a board with 4 pots etc. Does anyone have any practical experience? OEM manuals?

    Also one of my laser is 100% at 5vdc. I want to make it 100% at 4vdc. does anyone know which resistors to change?

    Thanks!

  2. #2
    Join Date
    Dec 2008
    Location
    Southport, UK
    Posts
    2,746

    Default

    Is it the driver that uses a seperate 12v supply?
    http://img62.imageshack.us/img62/3985/laser.gif

    Doc's website

    The Health and Safety Act 1971

    Recklessly interfering with Darwin’s natural selection process, thereby extending the life cycle of dim-witted ignorami; thus perpetuating and magnifying the danger to us all, by enabling them to breed and walk amongst us, our children and loved ones.





  3. #3
    Join Date
    Jul 2009
    Posts
    22

    Default

    Yes, Separate 12v PS, in the same enclosure though.

    Problem #1
    I have some leakage with 0vdc in.
    This I'm sure is a "simmer" current as I know they keep the current on below threshold to keep the TEC stable etc. Better blanking etc.
    So which pot controls the simmer current?

    Problem #2

    I have a lot of CNI green 1W lasers and some reach 100% at different voltages. I seem to remember when ordering they would always ask us what voltage we wanted for 100%. I think most are around 4v but some are 4.5v and 5v. I would like to change these lasers so 100% is at 4v. Any idea of what I can do?

    Thanks so much!

  4. #4
    Join Date
    Dec 2008
    Location
    Southport, UK
    Posts
    2,746

    Default

    http://img62.imageshack.us/img62/3985/laser.gif

    Doc's website

    The Health and Safety Act 1971

    Recklessly interfering with Darwin’s natural selection process, thereby extending the life cycle of dim-witted ignorami; thus perpetuating and magnifying the danger to us all, by enabling them to breed and walk amongst us, our children and loved ones.





  5. #5
    Join Date
    Jul 2009
    Posts
    22

    Default

    THANK-YOU! omg so helpful!

    So to stop my leakage I just adjust my zero bias, right?

    Do you know what the other pots do?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •