GM-20 Shutter driver

[DZ]

Ok guys, the shutter drivers are available www.dzelaser.com/store then click on Shutter Driver.

The folks that ordered the kits, I'll send info on how to pay either later tonight or tomorrow, they are ready to ship.

If you buy a driver, it may be 3-4 days before it ships, I only have about 6 built right now and will work on the rest asap.

These are designed to work off of a 5VDC power supply, however, if that doesn't cause the flag to move enough, then you can supply up to 8VDC. I think I mentioned before that in my projector the GM-20 driver runs on 5VDC, however, where it's mounted I needed to extend the flag a bit, that little bit of extention allows the setup to work perfect in my projector. By moving the flag only the distance you need, allows it to operate rather quickly. And with the damping I have built into the driver, it closes with little to no bounce at all.

Thanks guys, I hope you enjoy them and find them to be useful.

PS- As a test, I tied 5 of these together in parallel and attached them to 1 QM2000 with 100 feet of ILDA cable and all 5 actuated just fine.

[allthatwhichis]

I grabbed a couple along with a key.

[ljk]

Thanks DZ I just placed my order!

[-=Jim=-]

Thank you again DZ. Order placed...

[MisterWilling]

Thanks, I just placed my order for a driver.
Where can I obtain a GM-20?

[allthatwhichis]

Two drivers and a key switch recevied; thanks David!!!

[ljk]

Thanks for the fast service. I look forward to testing in out in my projector in the next few days.

LJ

[ImageLight]

Will be placing my order for 5 drivers soon. Thanks DZ

Mark

[-=Jim=-]

I received my 2 drivers as well. Once again top notch work David !!!

[DZ]

Thanks guys! I hope these work well for you projectors! I just installed one in mine and it was a piece of cake! Here's a pic, sitting right near my next idea.