is anyone working with these? laserwizardry, and i tried to get spitzstp's set hooked up and running last night.
hooked up +/- Y from the ilda break out board
hooked up +/- X from the ilda break out board
hooked up 12v and ground from a 12v psu (metered at ~11.86v) to lower right hand 12v jst connector.
no results. no leds on the board lit and the galvos didn't twitch.
verified 12v and gnd. tested cables for continuity. all seemed well. double checked manual found a passage that states " Input power is 12VDC, 2A max and is protected by a 2A fuse with a reverse voltage/over voltage clamping diode." so we tried reversing the 12v/gnd lines.
sill nothing.
so, what's the trick?
suppose you're thinkin' about a plate o' shrimp. Suddenly someone'll say, like, plate, or shrimp, or plate o' shrimp out of the blue, no explanation. No point in lookin' for one, either. It's all part of a cosmic unconciousness.