Hey,
please donīt laugh about my question.
Is it possible to connect a key switch between the psu and the laserdrivers???
Or is it a bad idea?could it damage my Drivers?
Sorry for being such a noob.
Thanks,
StarryEyed
Hey,
please donīt laugh about my question.
Is it possible to connect a key switch between the psu and the laserdrivers???
Or is it a bad idea?could it damage my Drivers?
Sorry for being such a noob.
Thanks,
StarryEyed
How about before the PSU's?
Also incorporate a delay.
My keyswitch is this:
http://www.reichelt.de/Schluesselsch...c2636a50d774c8
and im not sure if 230v is to much for it.
StarryEyed
The way I have my interlock wired I have a relay before the laser power supplies and a keyswitch for the shutter signal. The relay has to be closed AND the shutter signal key switched before any laser light gets out of the projector.
Love, peace, and grease,
allthat... aka: aaron@pangolin
Thatīs what i meant.
But what about:
PSU 5v ->keyswitch->LD-Drivers
PSU GND->---------- ->LD-Drivers.
???
StarryEyed
One sure way to get it all wired up correcly and with start delay etc is to use our ilda interface board. This is exactly what it was designed to do.
http://shop.stanwaxlaser.co.uk/ilda-...board-55-p.asp
Rob
If you need to ask the question 'whats so good about a laser' - you won't understand the answer.
-----------------------------------------------------------------------------------------------
Laserists do it by the nanometre.
Stanwax Laser is a Corporate Member of Ilda
Stanwax Laser main distributor of First Contact in UK - like us on Facebook http://www.facebook.com/FirstContactPolymerCleaner
www.photoniccleaning.co.uk
Thanks for that offer but i did not want to buy something.
I only want my question answered.
starryEyed