Printable View
Good Morning
I purchased the card FlexMod p3 (interlock monitor output).
Now I was trying to do the setup, but I always have the red LED on and no output, can not figure out how to maintain closed interlock.
Can anyone help me
thanks 1000
Google translate
The manual can be downloaded here:
https://innolasers.com/shop/index.ph...roller=product
It says: Iterlock must be connected to V+.
This thread gives you a good idea of what and how.
http://laserpointerforums.com/f51/ho...ser-56572.html
Everything's already properly set up. The interlock light is pulsing on/off for a few times before it stays on.
Everything's already properly set up, as can seen from the pictures. The interlock light is pulsing on/off for a few times before it stays on.
Everything's already properly set up, as can seen from the pictures. The interlock light is pulsing on/off for a few times before it stays on.
Also, my setup is different because of the modulation from arduino.
I'm unsure what happened on this thread, could a kind mod remove my triple post?