Results 1 to 7 of 7

Thread: laser range finder

  1. #1
    Join Date
    Aug 2009
    Location
    Beijing
    Posts
    34

    Default laser range finder

    have some one knows the laser range finder? how about the principle of operation? I do not know how does the Cr:YAG affect it as a Q-swicth?

  2. #2
    Join Date
    Jan 2009
    Posts
    1,622

    Default

    I don't know if the SSY1 or the Hughes Ruby rangefinders have ever been passively q-switched with a crystal experimentally before.. It could be interesting since they use a motorized prism in one case and a dye cell in the other IIRC. Cr:YAG should work fine @ 1064nm, depending on the dopant level.
    Last edited by ElektroFreak; 04-14-2010 at 08:57. Reason: numerical error

  3. #3

    Default

    Quote Originally Posted by Jiepu-Crystal View Post
    have some one knows the laser range finder? how about the principle of operation? I do not know how does the Cr:YAG affect it as a Q-swicth?
    As far as I know, the principle is simply measuring light's time of flight from the laser to the target and back to detector, this method is called TOF (time-of-flight). There are two kinds of optical TOF range finders: pulsed and CW. I assume that if one uses a pulsed laser it's a pulsed TOF :P

    Cr:YAG crystal is often used as a passive Q-switch in Nd:YAG pulsed lasers. Q-switching causes that the emitted light pulse is shorter in time. The pulse energy is not changed, so if the pulse is shorter it has higher power. I'm not sure if in case of a range finder Q-switching is used rather for increasing the power or shortening the pulse, but I think that it's rather a matter of power.
    http://c4r0.byethost9.com/ - If you like lasers, high voltage, x-rays and stuff like that, check out my website

  4. #4
    Join Date
    May 2008
    Location
    Wisconsin
    Posts
    449

    Default

    How would a CW rangefinder work? Unless it labels every photon leaving the device, how would it know which photon was returning when?

  5. #5

    Default

    Light amplitude is modulated and the flight time is obtained from phase shift in modulation signal.
    Last edited by c4r0; 04-14-2010 at 09:02.
    http://c4r0.byethost9.com/ - If you like lasers, high voltage, x-rays and stuff like that, check out my website

  6. #6
    Join Date
    May 2008
    Location
    Wisconsin
    Posts
    449

    Default

    Ah, so it's constant wave... with a real wave? Neat

  7. #7

    Default

    Hmm, kind of. It's called CW because the laser is not pulsed but modulated with sinusoidal signal, and as far as I know, it's never totally turned off (signal has higher offset than amplitude).
    http://c4r0.byethost9.com/ - If you like lasers, high voltage, x-rays and stuff like that, check out my website

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •