Page 2 of 2 FirstFirst 12
Results 11 to 14 of 14

Thread: Idea: Mixing 532 with 445

  1. #11
    Join Date
    Aug 2008
    Location
    UK
    Posts
    5,704

    Default

    Quote Originally Posted by -bart- View Post
    QS has a rgv-colour mixing profile that is intended for 405.
    Briefly mentioned here.
    That does what you describe.
    The mixing algorithm is fixed and hidden though.
    I'm not sure thats the same Bart.

    So far as I'm aware whilst there is a seperate profile for an RGV projector in the colour setup section of the projector set up menu, thats not the same as a seperate mixing control or mixing RG B+G.




    You can control the colour profile of an RGB projector through QS by adjusting the threshold voltage and max voltage of each R G B channel. However, there's no scope for cross bleeding channels that I'm aware of unless you can defeat blanking via the low voltage adjustment as I mentioned above but even if this is possible, you'll end up with a colour leak not only into the blue but also into the red.

    In QS, you could run the RGV profile with an RGB projector but if its fixed then the results are going to be a shot in the dark as to colour balance and unadjustable except as above ie the amount of green leaked in will be fixed (although you could turn the blue element down via voltage you can't turn the green element up or down thats leaked to that channel).

    I think in the absence of software that allows mixing, what you really need to have full adjustment is something hardwired to leak a small amount of voltage to the green sufficient to take it above blanking level when the Blue channel is active. That said, I would think the implication for this would be that you couln't run the green at full power as you'd have to set the max voltage for green at green voltage + leak voltage to avoid overdriving it wouldn't you?

  2. #12
    Join Date
    Nov 2005
    Location
    Melbourne, Australia
    Posts
    3,702

    Default

    Quote Originally Posted by White-Light View Post
    That said, I would think the implication for this would be that you couln't run the green at full power as you'd have to set the max voltage for green at green voltage + leak voltage to avoid overdriving it wouldn't you?
    Just clamp the output of the colour mixer circuit to avoid over driving...
    KVANT Australian projector sales
    https://www.facebook.com/kvantaus/

    Lasershowparts- Laser Parts at great prices
    https://www.facebook.com/lasershowparts/

  3. #13
    Join Date
    Feb 2008
    Location
    East Sussex, England
    Posts
    5,248

    Default

    i would hope that the driver design would prevent mod voltage from going over 5V if greater than 5V was applied

  4. #14
    Join Date
    Jun 2010
    Location
    Australia
    Posts
    3,733

    Default

    Thanks for all the ideas guys. I think I will build an op-amp mixer in the first instance.
    This space for rent.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •