I had posted about trying to get an old ILT 5500A argon head running. Djmatt happened to have the right supply for it so I bought that and it arrived today.
It works! Took about a minute to start up the first time but fires right up after time-out every time now.
Had a couple issues, first the power supply was intended to run off of 208v, not 240 which I have here. I popped it open and managed to figure out which taps on the filament and small signal transformer were for 240 and swapped around the wires. Second problem is this power supply only supplies 120v to the fans, not 240 for the fans that were installed, simple fix, replaced the fans. I also found that the fans only come on when thermal switches in the head turn it on kind of worried me for a minute. This way the fans shut down after it cools even if you turn off the power supply.
After a little mirror tweaking I got 4.8 to 5v out of the Power Monitor jacks on the side. I am thinking this is 480 to 500mw which would make sense, the optics are TEM00 broadband. The only power sensor head I have is a Coherent 150W unamplified head. It responds but at .06v/w it does not give me any useful info. A friend has a bunch of laser power meters so I will borrow one to test it.
Ill post some pics later.


Reply With Quote










Vidal Wolf
