finally got around to starting a micro rgb projector, had the bits kicking around for months now just no time to start
this is the first of twins as i have enough parts for two.
first up is the case thanks to fellow member for selling me two of these .
the build area is only 180mm wide x 240mm deep x 90mm high , here's a couple of pics with a ciggie pack to give an idea of size
resized_IMG_0063.JPGresized_IMG_0064.JPG
the power suppy a high powered +-24v supply thats only 100mm x 100mm x 35mm
to run scan set, also
off that i will run two dc-dc converters , one gives 5v @ 12a for all the lasers.
the other gives 12v @ 4a for the tec cooling via a die4chill
the power supply also has built in output to run cooling fans
resized_IMG_0047.JPGresized_IMG_0065.JPG
the lasers are 1x 500mw lasever 532nm doing around 600mw 1x 445nm set to 800mw 1x mitsu 300mw 638 being run at 600mw but
nice and cold and sealed . diode drivers for red and blue are a couple of die4drives,
resized_IMG_0046.JPG
i am aiming at around 1.5w output with a nice white with this build and around 2w with the second by adding an extra red or using
a single p73 red diode pushed to 1w
resized_IMG_0044.JPG
the lasers and scanset(pt40's) are all mounted on a 5mm plate that slides out for maintainence, as there going to be no access to diodes an mirror mounts
when power suppy and drivers are mounted above the lasers .
thats the story so far will update with more pics as i get bits done




Reply With Quote
dave

