I got a ML10 250 from the bowling alley where I work. It was taken down a few years ago to do some painting, and never re installed. Is there anyone or anywhere I could send this to and make sure its still operable and/or repaired. All cables were cut, but I think its all here. dmx, scan head, sc100, keylock,etc. Any help would be appreciated Thanks Kelly


Reply With Quote
..and half a dozen or so, posted-here, might just be about all the help you'd need.. this community is really-awesome at helping folks with cut cables... 
hauling-out of storage / listing-up, here, and also eBay, a bunch of old ML-parts / some chassis / boards / actuators, positioners, etc, and so, I am sure, between him and another tech we have here (..NOT-myself, I'm way-too over-loaded..
I am sure we could get it up and running, if you haven't by then...
....and armed only with his trusty 21 Zorgawatt KTiOPO4...
, I've got 'em.) The first one is a fairly standard 3 pin cable - you don't have to buy "DMX" rated cable at this point - just a microphone cord is fine. It will go between the keyswitch box and where it says "remote interlock in" on the back of the mobo. (I think 2nd from the left.) That's what basically turns the thing on and off.
