Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: beam artefacts...

  1. #11
    Join Date
    Feb 2008
    Location
    Northern Indiana
    Posts
    921

    Default

    Looks like a scanner tuning issue.

    Try projecting a few single "hot beams" at different angles. If the beams look good you have ruled out an optics problem.

    I would try projecting the laser media image to look at how well the scanners are tuned. Better yet check the tuning with a o-scope.

  2. #12
    Join Date
    Feb 2011
    Location
    New Hampshire
    Posts
    3,513

    Default

    To rule out the optics as opposed to the mechanics such as the scanner and the electronics such as the frames, you must look at each laser prior to the scanner. This will also allow you to evaluate the beam quality for each color. This is easy. Just interrupt each beam and send it to a surface. Interrupt the combined beam likewise prior to the scanner to confirm far field co-alignment and spot size to eliminate halos. Then, a static beam through the scanner to evaluate the scanner mirrors and the lack of jitter in the amps. Then...etc

    It is useful to mount a good clean first surface mirror on a SMALL metal block that you can insert to interrupt these beams. It should have a nice square, flat base and a convenient extension to allow you to fine tune the angle/position. A matte surface on another block without a mirror makes a good beam stop and angling this away from you minimizes scattered brightness and avoids burnt bits of plastic or index cards with small holes.

  3. #13
    Join Date
    Jan 2006
    Location
    Charleston, SC
    Posts
    2,147,489,632

    Default

    Quote Originally Posted by logsquared View Post
    I would try projecting the laser media image to look at how well the scanners are tuned.
    This right here! Post a picture of the Laser Media test pattern.

    Adam

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •