For the money, I think they are great galvos, don't get me wrong. They just won't perform at the speeds @ angles of which they are advertised. If I were doing shows for money, I would probably get some better glavos and keep these for backups.
This is relative. The gain may be set differently from scanset to scanset.That's interesting. So what are you able to hit when the image is completely maxed out x and y in the software?
If you're the smartest person in the room, then you're in the wrong room.
Well the reason i ask is i want to see the performance drop in his case(compare them to what i get now). i know every scan set tuning will be slightly different.
The pt's I have and I do have a few sets all preform great. I personally just wouldn't put my reputation on the line with them, perhaps if you have a second projector as backup that could work.
Also may want to ping planters as I know he has done a bit of testing positive iirc on the cheapo's
leading in trailing technology
So apparently the PT's that im getting do not have the polyswitch. The polyswitch is on the knock offs
Nope. There's no correlation between the software setting and what the max the scanner can do as its down to the individual scanner. The Software can push your scanners to destruction if you're not careful.
I run my size at 50%. I can take it to around 70% before it starts to show aberrations in beams (circles start to show tails) with my scanners, less of a size in graphics. Approaching 80% and with many cues mine get noisy. Luckily mine are protected but if you have an unprotected set, pushing it too far can be fatal.
Ultimately the size you set will depend on what you're projecting and your scanners capability but there's nothing in the software to stop you destroying them if you go too large. So its best to start small and adjust upwards if you want to go wide paying attention to the warning signs.
But as I mentioned before. I tune my scan rate at 100% size in the software and get the circle to just touch the box, which is around 12-13k