Amazing work David and thanks for sharing.![]()
Amazing work David and thanks for sharing.![]()
Thanks again guys for the kind words.
That's an interesting question! It would be nice to have a nearly invisible beam exciting the strontium aluminate (SrAL) or zinc sulfide (ZnS). Except for the inherent dangers, of course.
In my observations I can tell you that at least from IR down to 515nm, there is no glow effect on either material. Actually that isn't quite true; SrAl will glow slightly when exposed to certain ranges of IR although the reaction is faint. I discovered it by accident when I was applying the paint to test panels early on and brought them into the garage at night in near freezing temperatures. Where my fingers touched the panels, it glowed. I later confirmed this during my attempts to erase the glow from SrAl with a variety of IR diodes.
Anyway, my (unmeasured) observations showed a significant difference in the glow you get from a 450nm vs 405nm source with the same output. 405nm works better, of course, so the sweetest spot is somewhere down there. I found that a tight beam that isn't too powerful is preferred for drawing. For example, I draw (fast) with 750mW of singlemode 405nm max. Both SrAl and ZnS paint fully saturate with that kind of power, so it can be dialed down significantly. A 750mw 405nm beam is so bright it excites the area around the beam contact point to some degree.
I'd be interested to hear how 355nm works out. Is it a single mode diode? What kind of output are we talking about?
-David
"Help, help, I'm being repressed!"
If I whistle "Under The Sea" one more time today.... I'm coming to Fort Mill even sooner than expected. Grr..... Lol
PM Sent...
Home Disco - Disco + (Moon Safari^slow abstracts) = Home Moon Lounge
Love it, DK! Thanks!
Hi David, thanks for the warm welcome. I am pretty keen on the 506 with the X laser driver for the points you make. I have a 12V sound system so this would potentially just plug straight in with no hassle. I am mainly after beams to start with anyway, graphics will follow but I suppose I could always change the drivers later, the X laser deal is pretty good at the moment even considering the exchange rate to the UKP, similar price to the DT40 etc.
My projector is taking shape now, should be around the 6W mark with 1.4W red, 1W green and 3W blue, but may overdrive the reds to 2W to get better colour balance, I am just mounting everything at the moment on the optical table, next step will be getting the optics sorted to correct the beams.... Really enjoying it and after seeing your setups I am re-motivated...
Thanks,
Dupe...
Nice work as always, Dave!
David - will you be bringing any of these with you to FLEM? Would be cool to see some of them, especially the glow-in-the-dark unit!
John - thanks for the tip on the affordable 12V PSU. I've got a new project that revolves around the Compact 506 Scanners with the X-Laser 12-volt single-ended scanner amp, and that PSU is exactly what I needed. Just ordered 10 of them.
Adam