
Originally Posted by
Greg
I'm thinking how to get these shows up and performable / recordable / editable / watchable with as little hardware building as possible. With the scheme given in the attached graphic, one would need their choice of cycloid generator, 4 Bela units, 4 ILDA capable projectors, a couple of joystick pots and a few simply wired push buttons, and the interface board described in the graphic. What is needed is a large number of repetitions of a few simple op amp circuits. Perhaps I will have to try my hand at using the crate of historic wire wrap materials provided by Brian, but this would only generate a one off, and reasons may arise for having more than one of these systems. Alternate suggestions, offers to help with a pc board design / layout, or suggestions of a place I could pay to have one done, and critiques of my naively contrived voltage scaling circuits welcome.
In reference to the top schematic:
I don't see how your +-10v to 0->+5v converter schematic is going to work that way it is drawn. It's output will not always be unipolar with the scaled down plus and minus 10v signal swings.
When the input is +10v the opamp output will be -1.75 +(-2.5) or -4.25. And opposite this on the negative 10v signal swing, and not quite to the 5v target value.
Divide the bipolar 20v p-p signal down to a bipolar 5v p-p (plus and minus 2.5v) then add an offset of +2.5v. This resulting signal output will an inversion of the original input. This +2.5v offset would be "added" by it being an input on the non-inverting input. If you are going to "add" it on the inverting input the offset voltage polarity must be reversed to -2.5v. If you want to maintain signal polarity integrity but with an added positive offset, add another unity gain inverter at the end.
Also, to derive the small offset voltage for the opamp circuit you do not need to drive so much current through the 50K pot by using 30v across it (+15v and -15v). Just use a single source voltage polarity (e.g. +15v) that is the same polarity as you want to appear on the wiper of the pot (e.g. +2.5v) and leave the lower side of the pot's resistor grounded.
In reference to the 2nd schematic:
The gain of the opamp is 4.7, so worst case, +5v x 4.7 = +23.5v p-p. To center this p-p signal (lower it's DC offset) so the signal is centered around 0v, the non-inverting input needs to be at 23.5v / 2 = 11.75v as a negative voltage input, not positive. And again, all that is needed to get -11.75v from the pot's wiper is for the pot to be connected to -15v and Gnd. But then, this leaves you with a plus and minus 11.75v signal, not a plus and minus 10v signal, so some gain adjustment tweaking with the opamp's feedback resistor is called for as well.
Last edited by lasermaster1977; 11-29-2022 at 12:22.
________________________________
Everything depends on everything else