
Originally Posted by
Greg
Here is the chopper driver card schematic from a package of documentation for the Mk4 received from John Tilp. My ability to read schematics is less advanced than some here, so I'm not sure exactly what the circuit described does. My understanding is that the chopper was a scanner, not a spinning motor. Is that possibly an astable multivibrator in the upper left?
Where it says 100% adjust looks like it is generating a +-15V adjustable offset. It would be interesting to know what potentiometers the operator used as chopper controls, and if a useful square wave generator is shown here.
The missing variable potentiometer could be most any value where its full resistance plus the 3.3K Rin to the 2nd op amp and it's .22uF feedback resistor makes up an integrator that generates a triangle-like waveform. The triangle wave is feedback to the positive input of the first op amp thereby creating positive feedback to the integrator's input resulting in oscillations.
The output of the integrator is further modified by the parallel cap and 10K resistor and serves as one of three inputs to the 3rd inverting summing op amp. This op amp sums two inputs all the time, the Intensity input, which must be a voltage (variable? who knows) and the 100% Adjust voltage. The integrator's output signal is summed with those two signals whenever the Q2 FET is turned on making it in effect a short circuit between and connecting the 10K/.01uf input resistor/cap combo as a third signal to sum with the other two. The Chop EN signal turns ON Q2 to connect the integrator output as an input to the summing op amp.
Edit: Try putting a 100K or 1M pot across "8" and "10" (wiper on "8", one end of pot on "10") and see how the signal output at pin 7 of A1 changes in frequency as the pot is turned.
A lot depends on how the galvo is used mechanically or optically to achieve chopping.
Seems like there would be an easier way to do this if the Chop Output is driving a G120D or similar.
At least that's my best guess.
Last edited by lasermaster1977; 11-05-2024 at 17:59.
________________________________
Everything depends on everything else