Hi Adam and all,
I am in Albuquerque, NM. Here is a picture of the PSU. I believe it is an HGM-5 because it seems to match pictures of other HGM-5 PSU's I have found and the control board says HGM and E5-00-07-057 Rev D. There are no other identifying marks I could find. I have made several photos but, as I'm not sure how welcome many large images are on this forum, I have included just two for now called HGM5 Front-Top Marked.JPG and the laser head: ALC-905.JPG
Here are my guesses so far as to what the marked wires and components are:
A - No idea - Appears to go to the power switch in some pictures I have found.
B - No idea - Two separate wires.
C - No idea - Two wires bared & twisted together.
D - No idea
E - Power to cooling fans
F - No idea - Two wires coming from under the control board.
G - One Anode wire & two Cathode wires
H - No idea - appears to be incoming power in another picture I found.
I - No idea - Temperature sensor or light feedback maybe?
J - Is this a series injection transformer for starting the tube?
K - Filament transformer?
I can add more views later if needed. The ALC-905 was from EBay. I don't know if it is any good or not. The only test I have done so far is to briefly put a 15KV neon sign transformer across anode and cathode resulting in a pale bluish glow in the tube.
Any assistance you can offer would be most appreciated and I would be eager to see pictures of your HGM-5 / ALC-903.
Thanks,
Roger


Reply With Quote
buffo
It is indeed an HGM5 power supply, and it's identical to the one I have. (Well, mine still has all the dose-related computer circuitry attached, while yours is just the "guts" of the PSU. But they're otherwise the same.)
The LED's on the control board don't light up and on further testing there was no power on the control or driver boards. I think I am probably missing one (or more) interlocks. Does your HGM-5 PSU have anything connected to the 26 pin connector on the back? The schematics arrived today and have already been very helpful. I assumed the laser used a series injection transformer in the anode line for starting the tube. I made a big toroidal 80:2 transformer for this purpose but the schematic shows the ignition going straight to the body of the tube. Perhaps that explains the tiny ignition transformer I see in your pictures since it does not have to carry the full anode current. With enough study the schematics will probably help me find all the interlocks but I am not there yet. Thanks again for the schematics.
