Lasernerd threatening to bail?!
Why?
I have anode blocks and magnets for him
Senior Member
Lasernerd threatening to bail?!
Why?
I have anode blocks and magnets for him
Senior Member
Oh yeah and Dave (daguin)
I have some long-awaited goodies for you as well
Senior Member
the condition for him to actually receive them is that he must show upOriginally Posted by GooeyGus
Lasernerd threatening to bail?!
Why?
I have anode blocks and magnets for him
Pat B
laserman532 on ebay
Been there, done that, got the t-shirt & selling it in a garage sale.
Senior Member
hey pat, quick question.
What triggers the 'ready' light to come on in the 265? Is it just a time delay? Last time I fired up the 168 it didn't light... The laser lit up just fine though. I fixed the water light... But now I think my ready light went tits up....
Senior Member
oh and one last thing...
I plan on arriving between 7 and 8pm.... will I be able to unload my gear into the 'venue'? I would just rather not have it all sitting in my car overnight...
*This space intentionally left blank*
I have one you can use at my place, if needed. It's a Hitachi 1/2" with LASERS.
-Jonathan
Senior Member
The ready light comes on when the time delay relay closes (glass tube on alarm board) that is why it is a good idea to check your voltage across the tube if it is 540 vdc your start ckt is fine, light is bad if 250 vdc start ckt is not working (tube sometimes starts, but most the time it wont) They are 250 volt neon hard to come by (may be 110 volt look on the side of the light) hell i dont remember, but we can figure her out.
load in fri night should be no problema - god I hope we get site a- it is bigger and better.
Pat B
laserman532 on ebay
Been there, done that, got the t-shirt & selling it in a garage sale.
Senior Member
sears has em about 59.oo it is a POS but it works, i have one here and may if we get time we can make something, I have a mill but time is limited unless you and I work at night, what evI have one you can use at my place, if needed. It's a Hitachi 1/2" with LASERS.
-Jonathan
Pat B
laserman532 on ebay
Been there, done that, got the t-shirt & selling it in a garage sale.
Senior Member
*fingers crossed for venue A*
Senior Member
80 % there update later today!*fingers crossed for venue A*
Pat B
laserman532 on ebay
Been there, done that, got the t-shirt & selling it in a garage sale.
Posting Permissions
Reply With Quote