Hi,
What kind of effect or symptom do you get when an argon has it's mirrors at a different distance to factory spec?
I had to change the alignment on my NEC3030 since it wasn't lasing when i got it.
Luckily a gentle push on the mirrors gave a flash and i was able adjust the alignment screws to get the mirrors parallel again.
The thing is, I'm not sure about the distance (moving all 3 screws together).
What effect does that cause, or what symptom (if any) means the distance might be set wrong?
Is it even that critical?
Currently the laser outputs 488nm with a beam diameter of ~1mm at the head and 20mm after ~8meters.


Reply With Quote
