In light of a couple of recent posts on mounting a Laserwave Laser controller.
I thought I’d share the method I used for mounting the laser controllers (or three of them)
It’s simple a strip of Aluminium with holes drilled in either end that slots into the outer slot of the heatsink fin on the controller.
One bracket three power supplies
The added bonus of this is that it clamps the heatsink to the base plate to aid cooling; also the power supply can be removed in a very short time by simple loosening two screws and swapped out.
To mount the power supply this way you may need to trim the glue and the two switches to allow it to mount flush (without damaging the switches)
Troy



Reply With Quote


dave
