Building a Lumia Projector

[PhantomRage]

445 473 532 589 660

I have a 632.8 15mw HeNe...

[flecom]

I have a 632.8 15mw HeNe...

ya I also have a hene around 10mW... but for the sake of size I think I'm going to go with a 20mW 635 diode

[PhantomRage]

ya I also have a hene around 10mW... but for the sake of size I think I'm going to go with a 20mW 635 diode

Ya the Melles griot tube is 17inchs long.

[flecom]

and a diode is like, 2 inches

bought a 20mW 635nm diode from modwerx for $19... not too horrible

[mikkojay]

Nice one flecom- I may have to blatantly rip off that angle AL frame setup ya got there
I put mine on hold for a little while, I had so many components I wanted to stuff in there, I swore my enclosure was too small.
I did score a dmx-it on ebay for cheap, I think it will be perfect for running a lumia box.
Looking good, keep the pics comin'
-Mike

[flecom]

I stole the design from the lumia table I bought from DZ many years ago

[dnar]

Has anyone tried to make Lumia wheels by heating those clear discs used to protect the top disc in a stack in an oven?

[VJ AIWAZ]

if you need .5 rpm motor you could always buy of these and take the motor

http://www.ebay.com/itm/optikinetics...item3f52d31b84

[Displaser]

Has anyone tried to make Lumia wheels by heating those clear discs used to protect the top disc in a stack in an oven?

Might be a too thin, but probably doable if you are careful. I'd skip the oven, take it outside and torch it until it starts to bubble a bit.

Greg

[polishedball]

Might be a too thin, but probably doable if you are careful. I'd skip the oven, take it outside and torch it until it starts to bubble a bit.

Greg

missed ya at SELEM. Had my Lumia rig there wish we coulda talked some. Hopefully next year.