If you're the smartest person in the room, then you're in the wrong room.
Just so i know im thinking the right thing.
When i adjust size and position, in projector settings, in Beyond. If I stretch that box as wide as it goes, that is only making it as wide as the scanner was designed to do right?
So what would be considered pushing it?
Im not sure what scanset is in my CS series lasers. but i run them as wide as the software allows and assign scan rate to a fader on my midi.
I "tune" them in the software with the ilda test pattern as large as the software will allow me to (in the size and postion section). as soon as the image starts to draw tails/stops flickering/circle gets too big, i back it off just a bit and set that as my max in beyond.
This way during the show i can use the fader to make the image flicker really bad by bringing scan rate down to 6k on a complex set of beams to give a strobbing flicker effect. I can also do the opposite and smooth the beams out by adjusting it the other way to my max.
Those scanners (in my current lasers) will draw that ILDA30k pattern at about 12-13k (with flicker) when i have the size stretched all the way to 100% of what the software will allow x and y
It took me almost five years to acquire all the stuff I have now and I haven't even begun on my lumia projector yet. I am still amassing parts. Sometimes, as painful as it is, you have to save up.
If you're the smartest person in the room, then you're in the wrong room.
I'm the poster child for way more than I should.
Ok so, here's a question based on your statement:
Basically, you should always tune your scanners to run at the speed and angle at which you intend to use them.
Are you suggesting this on a per show basis? I don't claim to be a scanner or tuning authority. Yes, I've been hand held through the process a few times and have assisted others with their tuning but, it's just been simply a matter of setting the projector up, shining the ILDA 30k test pattern on the wall and tweaking the circle in the box to make sure it's round and touching the edges of the box. I know to do it accurately for a particular scan angle you need to have the projector a specific distance from the wall and the actual test image set to a certain size and we've done that with a tape measure. But, then I'll just use the projector for whatever. It might be set stupid wide for a beam show one night and then a week later be showing graphics on a wall. I don't do anything different with the tuning at that point.
Edit... Oh, and since I didn't "go away", I should address the OP's answer. I have 4 sets of PT40's from Lihtspace and so far, I'm very pleased with them. I haven't really pushed them too hard yet because I don't want to have to buy another set of scanners to replace them but, thus far, they've been great.
This is exactly what i was referring to. Every setup is different and none are permanent installs. IF the room permits i run as wide as an angle as possible and usualy rather narrow (i have also noticed better scanner performance, the smaller the scan area (regardless of how wide) the better the performance. these are just my observations)
My friend speaks pretty highly of the PT scanners, but i really like getting objective and subjective viewskeeps me aware of potential problems.
Well, this is what I got from Adam when I was having trouble with my polyswitch on my PTs and this is how he explained it to me...... This is from a PM.
So, I take that to mean that if you are not going to run your galvos at 40K but they are tuned for 40K, they are going to be working harder than they need to. This is why I prefeaced this with "Adam may be able to help"Originally Posted by buffo
After this PM, I retuned my glavos and was able to hit 13.5° at 30K with no problems.
If you're the smartest person in the room, then you're in the wrong room.